Description-1 7/8”bore Pillow Block Bearing Unit UCP210-30
GJP Bar Code Number: 6935329802247
GJP 1 7/8" Pillow Block Bearing Shaft UCP210-30, Which has grease fitting and Cap on 45 degree angle, and the insert bearing has a wide inner ring with two set screws for locking on the shaft, bearing insert and housing are normally assemblied with J7 tight fitting, this items are widely used.
Fafnir: RASC-1 7/8”
Fafnir: YAS-1 7/8”
RHP: NP-1 7/8”
SKF: SY 1 7/8”TF
Center Shaft to Base Size
Center Bolt to Bolt Size
Housing Bolt Length
Housing Bolt Width
Technical Data for GJP UCP210-30
Housing No.: P210
Bearing Insert No.: UC210-30
Material For Bearing Insert: 100% Chrome Steel Gcr15(AISI 52100)
Grade For Steel Ball: G10 Grade Chrome Steel Ball.
Materia of Bearing Cage: #10 Steel
Stopping Pin Material on OD of OR: Chrome Steel Gcr15
Sealing Type: F Seal, L3 Seal And Normal NBR Seal are available for customers’selection.
Set Screw Material: 35CrMo
Grease: 20% to 50% Mobil Grease
Set Screw Surrounding Hardness: HRC49 to HRC 50
Bearing Race and Steel Ball Hardness: HRC59 to HRC62
Bearing Housing Material: HT200 Grey Cast Iron
Housing Color: Green, Blue, Grey, Black Color available.
Whole Unit Assembly Type: J7 Tight Fitting
Housing Weight: 1.83KGS
Quality Control: Under ISO: 9001: 2008 Certificate
Package: 1*1 Single GJP poly bag+1*1 Single GJP color box+1*1 GJP outer carton
If we have a project package order, we would send you the samples for quotation, can you analyze our samples and firstly quote? If quotation is accepted, how will GJP produce according to our samples?
Yes, if there is special bearings for packaging project, it’s better that you could send us samples, we could have our engineers to separate your samples and analyze them, firstly check from the out-looking, and the marking on the bearing, then check the clearance,running out and precision, then check the hardness on your bearings to make sure whether it is chrome steel, or stainless steel, or other materials, then we’ll analyze the grease data, how many voumn, and which kind of grease the samples use, finally we would check steel ball data, how many pieces of balls, which grade ball, and what material, and check the cage situation. Besiding checking, our staff would take a record and form it into a general ideas on your samples, then we’ll quote and give you suggestion, if quotation is approved, we’ll produce according to the record we have, but before production, we would firstly send you a drawings for double confirmation again.