Description-2 7/16”Bore Pillow Block Bearing Unit UCP212-39
GJP Bar Code Number: 6935329802346
GJP 2 7/16" Pillow Block Bearing UCP212-39 with 2 3/4" Base to Center, Which has grease fitting and Cap on 45 degree angle, and the insert bearing has a wide inner ring with two set screws for locking on the shaft, bearing insert and housing are normally assemblied with J7 tight fitting, this items are widely used.
Fafnir: RASC-2 7/16"
Fafnir: YAS-2 7/16"
RHP: NP-2 7/16"
SKF: SY 2 7/16" TF
Center Shaft to Base Size
Center Bolt to Bolt Size
Housing Bolt Length
Housing Bolt Width
Technical Data for GJP UCP212-39
Housing No.: P212
Bearing Insert No.: UC212-39
Material For Bearing Insert: 100% Chrome Steel Gcr15(AISI 52100)
Grade For Steel Ball: G10 Grade Chrome Steel Ball.
Materia of Bearing Cage: #10 Steel
Stopping Pin Material on OD of OR: Chrome Steel Gcr15
Sealing Type: F Seal, L3 Seal And Normal NBR Seal are available for customers’selection.
Set Screw Material: 35CrMo
Grease: 20% to 50% Mobil Grease
Set Screw Surrounding Hardness: HRC49 to HRC 50
Bearing Race and Steel Ball Hardness: HRC59 to HRC62
Bearing Housing Material: HT200 Grey Cast Iron
Housing Color: Green, Blue, Grey, Black Color available.
Whole Unit Assembly Type: J7 Tight Fitting
Housing Weight: 2.8KGS
Quality Control: Under ISO: 9001: 2008 Certificate
Package: 1*1 Single GJP poly bag+1*1 Single GJP color box+1*1 GJP outer carton
GJP offer Pre-sale services:
1. Providing professional technical support.
2. Send the product catalog and instruction manual, free samples would be sent if required.
3. If you have any question,PLS contact us online or send us email, we promise we will give you a reply at the first time!
4. Personal call or visit and audit factory are warmly welcome.
For the Cast Iron Bearing Unit, if we have the special requirements, and you need to open the mold, after we pay to open the mold, our company wanna to get this mold together with our shipment when the cargo is ready, is it acceptable for GJP?
Yes, of course, if your company pay the mold fee to have a new mold, you have the right to deal this mold, whether you wanna to put it in our factory, or you wanna to get it back to your factory, it depends on you, and normally our customers who open the new mold, they just keep the mold in our places, and we could use it whenever there is a new order in the future from your company, of course, we could pay you some if we think that this mold is useable a lot in our factory.